Tooling service
Diamond tool resharpening & tooling
You don't have to own one of our machines. Euracryl builds 2,700 polishing heads that fit 210 machines from 61 manufacturers — and we resharpen other brands' diamond tooling too.
2,700 heads
Euracryl polishing and milling heads in the catalogue, built for acrylic and technical plastics.
210 machines
Machine models covered, from 61 different manufacturers — including brands we don't sell.
Any brand
We resharpen other manufacturers' diamond tooling, not just Bermaq and Euracryl.
How it works
- 01
Request
Send the form below with your tool types, quantities and finish.
- 02
Ship
Pack the tools and mail them to our Orange, CA facility.
- 03
Inspect
We check each tool for wear, chips and runout before work begins.
- 04
Resharpen
Diamond edges are reground and balanced to original geometry.
- 05
Test
Tools are test cut on our own shop floor machines.
- 06
Return
Sharp tooling ships back with notes on what we found.
Ship to: CNL Edgeworks Inc., 2296 N. Batavia St Suite B, Orange, CA 92804.
What we service
Tooling, not just sharpening
Most shops call us for resharpening and stay for the tooling. Both sides of the service run out of the same Orange, CA floor.
Resharpening — any brand
Diamond cutters, finishers and milling heads reground to original geometry, balanced and test cut before they ship back. If it polishes plastic, send it.
Replacement & new tooling
Euracryl heads, cutters and finishers matched to your existing machine — including machines from other manufacturers.
Finish changes
Moving a machine from gloss to satin, or adding a gluing-surface setup, is usually a tooling change rather than a new machine.
Wear diagnosis
Edges going cloudy or chattering is often runout, feed rate or depth — not a worn tool. We tell you which it is.
Why it matters: a dull or out-of-balance diamond tool shows up as cloudy edges, chatter marks and inconsistent gloss. Regular resharpening keeps finish quality steady and gets more life out of every tool. Questions about a specific machine? Contact our tooling team.
Resharpening FAQ
+What diamond tools can you resharpen?
Diamond cutters, finishers and milling/polishing heads from acrylic edge polishing machines — Bermaq, Kuper Euracryl and other brands.
+Do I need to own a CNL machine?
No. We resharpen other manufacturers' diamond tooling, and Euracryl heads fit 210 machine models from 61 manufacturers.
+Where do I ship tools?
CNL Edgeworks Inc., 2296 N. Batavia St Suite B, Orange, CA 92804. Send the request form first so we know what's coming.
+Why resharpen instead of replacing?
A sharp, balanced tool keeps the edge finish consistent and extends tool life. Resharpening restores the original geometry so the tool keeps producing the finish it was built for.
+How are tools checked before they ship back?
Each tool is inspected for wear, chips and runout, reground and balanced, then test cut on our own shop machines.